Snow Foam Shampoo - 1000ml

Application Methods:

Snow Foam Shampoo can be applied via foam lance, hand foamer, or spray bottle. The recommended minimum PIR (Panel Impact Ratio) is 0.5% up to a maximum of 2% for very dirty vehicles. Dilution in a hand foamer or spray bottle is easy to determine. For foam lances, it is more challenging due to the water flow rate of the pressure washer.

Calibration Process:

You only need to perform the following steps once. Don't forget to note the ratio on the packaging for future reference.

1. Fill the mixing bottle with tap water to the maximum level.
2. Set the foam lance or the reservoir of the pressure washer to the maximum product flow.
3. Take an empty large bucket and spray with the foam lance into the bucket until the entire mixing bottle is empty. Stop immediately.
   • If the bottle is not empty and the bucket is full, halve the amount of water in the mixing bottle and start again. All subsequent figures should also be halved.
4. The following calculation provides a PIR of 2%. Measure the total number of liters in the bucket after the mixing bottle is empty. Multiply this number by 0.02.
   • The resulting number is the amount of product needed for the contents of your mixing bottle.
5. Mix the bottle with the desired amount of product and water.
6. Foam the car and let it sit for 1-5 minutes. Never let the product dry on the car. Rinse off with high pressure.

Example Calculation:

Using a pressure washer and a Monello Lancia Foam Lance with a 1000 ml mixing bottle:

1. Fill the mixing bottle completely with tap water (1000 ml).
2. Attach the foam lance to the pressure washer and turn the top knob all the way closed (maximum foam setting).
3. Spray into an empty large bucket until the 1000 ml mixing bottle is (almost) empty.
4. When the bottle is nearly empty, the bucket is filled with 13 liters of water.
   • The amount of product needed is 13 x 0.02 = 260 ml, and the rest is water.

Usage Notes:

• You do not need to use all the mixture at once; the mixture can be stored. You can also use half by mixing 130 ml of product with 240 ml of water.
• With one liter of mixture, you can perform about 8-10 washes, depending on your pressure washer and water pressure.