Auto-Foam - 5000ml
- Highly active snow foam
- Acid-free
- Safe for all surfaces
- Biodegradable
Auto-Foam is a premium pre-wash foam designed to optimize vehicle preparation. This water-based formula is created to remove dirt and contaminants from the paint before applying shampoo and other products like wash mitts.
It ensures a thorough clean without damaging the paint. Auto-Foam is compatible with all pressure washer and high-pressure foam lances and has an ideal PIR (Panel Impact Ratio) of 4%, as explained in the manual below. The foam remains active for five minutes to effectively perform its task.
The product is biodegradable, tough on dirt, yet gentle on paint. Its non-caustic formulation preserves the paint even with regular use. The foam breaks down gradually, allowing the cleaning agents to work and effectively remove contaminants. After use, Auto-Foam can be easily rinsed off, leaving the vehicle ready for subsequent treatments.
Not suitable for PET bottles; always rinse thoroughly after use.
| Product number: | 101252 |
|---|
Auto-Foam can be applied using a foam lance, hand foamer, or spray bottle. The minimum recommended PIR (Panel Impact Ratio) is 4%.
Follow these steps only once, and remember to record the ratio on the container for future use. Fill the mixing bottle with tap water up to the maximum level. Set the foam lance or, if using the pressure washer’s own reservoir, adjust it to the maximum product flow. Use a large empty bucket and spray with the foam lance into the bucket until the mixing bottle is empty, then stop immediately. If the bottle isn’t empty and the bucket is full, halve the amount of water in the mixing bottle and start over. All subsequent numbers should be halved accordingly.
To achieve a PIR of 4%, measure the total liters in the bucket after the mixing bottle is empty. Multiply this number by 0.04 to determine the amount of product needed for the mixing bottle. Mix the bottle with the calculated amount of product and water. Foam the vehicle and let it sit for up to 5 minutes. Never let the product dry. Rinse off with high pressure.
Example Calculation with a Pressure Washer and a Monello Lancia Foam Lance:
- Fill the 1000 ml mixing bottle with tap water.
- Attach the foam lance to the pressure washer and set it to the maximum foam setting.
- Spray into a large empty bucket until the 1000 ml bottle is almost empty. The bucket will then contain approximately 13 liters of water.
- The required amount of product is 13 x 0.04 = 520 ml, with the remainder filled with water.
11 - 3 of 33 reviews
Topkeuze
Reinigende werking : uitstekend. Afspoelbaarheid : uitstekend. Voor herhaling vatbaar : zonder twijfel. Schuimlaag : afhankelijk van de nozzle, maar het stelt je nooit teleur. Bilthamber foam is qua prijs kwaliteit een aanrader.
Beoordeling
Heb het nu een aantal keren gebruikt, maar kan eigenlijk niet zeggen welke verhouding het beste is. Het is een chemisch prutje en een laag schuim laat het niet achter. Alleen tijdens opbrengen (hoge drukspuit) zie je veel schuim, wat even later weer weg is. Paar keer 1 op 1 gebruikt ( 1 deel foam mengen met 1 deel water) Puur is mij toch te link op de nieuwe Alto. Maar vooral de achterkant is snel stinkend smerig. Volgende beurten ga ik toch een veel voordeliger verhouding proberen, 1:70 of zo. Je hebt maar een heel klein beetje nodig, dus gaat de bus lang mee. Hoop niet dat het de Waxoyl erg aantast.
Uitstekend
Beste foam tot nu toe, punt. Reinigt verreweg als beste, en voert vuil goed af. Tast de waxlaag iets aan, maar dat doet bijna alle foam en autoshampoo. Klein nadeel: minder geconcentreerd als de roze concurrent.
Shared on our socials.
Our #CleanRiders in action
Alternative products
- Zeer effectieve prewash foam
- Geschikt voor foamlans, handfoamers en zelfs sprayers
- Biologisch afbreekbaar
- Gemiddelde PIR van 1%
- Pre-wash snow foam
- Aggressive foam for very thorough cleaning
- Not pH-neutral
- Most effective snow foam on the market
- Produces thick foam
- Multi purpose
- Powerful cleaning action
- Safe on aluminium
- Citrus Power-Based Foam
- Safe for wax, sealant, and coating
- Loosens dirt and grime
- pH-neutral formula